-
What are the requirements for wall thickness of plastic parts
2019-03-08 1723
The wall thickness of plastic parts has a great influence on the quality. When the wall thickness is too small and the flow resistance is large, it is difficult for large and complex plastic parts to
-
What are the commonly used injection moulding materials?
2019-03-08 1585
Injection materials commonly used in injection moulding and plastic materials suitable for injection moulding, including PE PP PS and other plastics, have thermoplasticity and are suitable for hot inj
-
Analysis of the Defects of Plastic Formation
2019-03-08 1659
The reasons for the shortcomings in the processing of plastic parts are as follows:1. Injection material. Material has impurities or supplies from different suppliers, different batches from the same
-
What should be considered in the design of injection moulds
2019-03-08 1756
1. Considering the process characteristics of plastic raw materials, the moulding performance and the type selection of injection moulding machine may have an impact on the moulding quality, so corres